Funding Wizard

On hot summer days, energy demand increases because thousands of customers are using their air conditioning units. PG&E may remotely activate SmartAC devices on those days in order to help maintain adequate power supplies and avoid power interruptions.

If you're a SmartRate™ participant, on SmartRate™ event days, your SmartAC™ device(s) are activated under the SmartRate™ program guidelines. SmartAC is free and automated. It can also help make event days more successful by helping to prevent power interruptions.

Event season: SmartAC™ events occur between May 1 and October 31.

Event length: SmartAC events Days can be as short as an hour or two and no more than six hours in a day.

Participants must have standard central air conditioners and/or heat pumps.

SmartAC technology and activation

SmartAC™ technology will be installed free of charge by a certified technician and maintained at no cost to the customer as long as you are a participant in the SmartAC program.

The SmartAC authorized contractor is Franklin Energy. A Franklin Energy technician may contact you:

To help you complete your enrollment

• To get your permission to activate the SmartAC device
• To install the SmartAC device, which may involve replacement with updated technology
• To help solve a tech issue you may have contacted the program about
• To visit your home and carry out the free AC check-up
• To leave a Welcome Kit door-hanger with your AC checkup results and program details

SmartAC™ switch technology will be installed on or near the outside compressor component of participant's air conditioning (AC) unit. Participants must have standard central air conditioners and/or heat pumps.

PG&E may remotely activate SmartAC™ device(s) in anticipation of a state or local energy emergency to help maintain adequate power supplies and avoid widespread power interruptions.

During a SmartAC™ event (or SmartDay™ event for SmartRate™ participants), your device will be remotely activated and your air conditioner will run slightly less than it normally would.

Residential participants with SmartAC™ switch technology may experience no more than 50 percent reduction in the air conditioner's average run time.

During a SmartAC™ event, if your thermostat calls for the air conditioner to make cool air, your AC will ignore that signal for approximately 15 out of 30 minutes. At all other times, the AC will respond normally, and make cool air.

Opt out policy

With the exception of extreme energy emergencies, where rotating outages may occur, participants may call a SmartAC™ representative at 1-866-908-4916 and opt-out of an event for the day, without penalty. The AC will be returned to its previous operational setting.

The Residential Energy Efficiency Loan (REEL) program was designed to help California homeowners and renters access affordable financing for energy efficiency projects.

Owners of any residential property are eligible for the REEL program, as are renters at the discretion of the lender and with the property owner’s permission. Customers may upgrade a single-family home, townhome, condo, duplex, triplex, fourplex or manufactured home. And, with REEL, renovations for up to four units can be bundled into the same loan.

Eligibility requires that the property receive electric or natural gas service from Pacific Gas and Electric Company (PG&E®), San Diego Gas & Electric Company (SDG&E®), Southern California Edison (SCE®) or Southern California Gas Company (SoCalGas®). For complete program rules and regulatory information, please reference the REEL Program Regulations+.

Reduce before you produce! The REEL program prioritizes energy reduction (through energy efficiency) over energy production. At this time, lenders are not offering solar loans through the REEL program.

With different lenders and loan options, there’s a REEL solution for your home improvement needs.

The Affordable Multifamily Financing program targets multifamily properties where at least 50% of the units are income restricted.

Like all of the programs highlighted on GoGreen Financing, the Affordable Multifamily Financing program is designed to encourage growth in private market lending and features a credit enhancement to help financing entities mitigate risk. It is designed to leverage and complement existing state and utility efforts to encourage affordable multifamily properties to install energy efficiency retrofits.

Property must receive electric and/or gas service from any of the following investor-owned utilities (IOU):

• Pacific Gas and Electric Company (PG&E®)
• San Diego Gas & Electric Company (SDG&E®)
• Southern California Edison (SCE®)
• Southern California Gas Company (SoCalGas®)

The Low-Income Weatherization Program's (LIWP's) Farmworker Housing Component installs no-cost energy efficiency improvements and/or solar PV systems for qualified farmworker households. Funded by the State of California to help households save energy and reduce greenhouse gas emissions, the program lowers energy costs for families and makes other improvements to improve the livability of housing. 

Launched in 2019, the LIWP Farmworker Housing Component provides services in the 12 counties in California that have the highest farmworker populations, including: 

​​​FRESNO COUNTY - IMPERIAL COUNTY​​ - KERN COUNTY - MADERA COUNTY - MERCED COUNTY - MONTEREY COUNTY - SAN JOAQUIN COUNTY - STANISLAUS COUNTY - RIVERSIDE COUNTY - SANTA BARBARA COUNTY - TULARE COUNTY - VENTURA COUN​​​​TY